The latest from Coil Master is the fully upgraded DIY Kit V2. The original was already highly praised by advanced vapers for the building of coils, the new versa on vastly improved upon it. Some examples includes a superior quality snaps, stronger splint-wooded pliers, Phillips and Fat head screws for more versatile, and appealing foldable scissors. To further boaster the user experience, slots for all the tools are designed for better ergonomic use, with bigger gaps for easy handling. There is also additional slots for two batteries storage. Build latest coils, RBAs, and RDAs from anywhere, with this portable and dependable DIY KIt V2 from Coil Master!
Full Package includes:
1 x Diagonal pliers
1 x Needle-nose pliers
1 x Stainless steel folding scissors
1 x Pen styled cross Screwdriver
1 x Pen styled straight Screwdriver
1 x Ceramic Tweezer (T1) so you can fire your coils while squeezing to
1 x Elbow Tweezer (T3) to make all your adjustments.
1 x Kanthel wire A1 resistance wire, 24GA, about 3 feet
1 x Ohm Meter to measure the resistance of your atomizers
1 x Coiling Kit V3 (with inserts and rotary caps for 1.5, 2.0, 2.5, 3.0, 3.5 and 4.0mm diameter)
1 x Silicon rubber case
The two AA batteries required for the ohmmeter are not included.
Insert the socket screw into the appropriate hole of the winder section
Insert wire through hole on the side of the handle. Leave about 1/2" of the wire protruding from the hole. Hold the end of the wire against the handle so it won't pull through
Pull the loose end of the wire around the shaft
Slide the winder section over the shaft with the pin facing toward the handle
Turn the winder section so that it catches the wire and starts wrapping it around the shaft. Keep light pressure against handle while winding. Excessive pressure will force smaller gauge wire to wrap over itself
When finished, remove winder and straighten the wire end that protrudes from the hole in the handle
Push up on the wire to slide coil up. Carefully grab the coil at the bottom to slide it off the shaft